699-416

SUB-APPENDIX F11 - NAC FM NONLINEAR RESPONSE TERMS


The correction factors tabulated below correct for nonlinearity by

DN' = DN*C
where C is the correction factor,
DN is the observed DN (after dark-count and bias subtraction), and
DN' is the desired DN.

A correction algorithm can interpolate to get C as a function of observed DN for each pixel. This procedure should occur after the uneven bit weighting correction during the radiometric correction of each image. Note that DN' values greater than 4095 will result in some cases even though the data were not actually saturated. This fact will have an effect on the design of the radiometric correction software.
Correction factors for the four gain states are listed in the following table.

Gain 0
 
Gain 1
 
Gain 2
 
Gain 3
DN
C
DN
C
DN
C
DN
C

75.0

0.958 121.4 0.987 34.8 0.974 71.6 0.986
221.7 0.972 200.3 0.997 102.7 0.990 212.7 0.997
294.2 0.977 281.1 0.995 203.3 1.000 282.8 0.999
366.6 0.980 401.4 0.995 272.0 0.997 354.0 0.998
440.4 0.979 801.9 0.996 407.8 0.997 423.4 1.001
855.1 1.008 1201.5 0.997 815.1 0.998 849.8 0.998
1351.2 0.957 1439.5 0.999 1221.9 0.998 1273.8 0.998
1522.0 0.944 1755.4 1.001 1493.0 0.999 1415.4 0.998
1766.9 0.976 2068.9 1.004 1757.1 1.003 1697.5 0.999
2012.0 1.071 2534.9 1.008 2165.0 1.002 2118.3 1.001
2288.3 1.130 2997.4 1.013 2565.4 1.004 2537.5 1.002
2819.3 1.121 3603.9 1.020 3092.6 1.008 3091.9 1.005
3496.7 1.068 4095.0 1.024 3741.8 1.014 3640.4 1.009
4095.0 1.080
 
 
4095.0 1.017 4095.0 1.011


HOME BACK